The WiFi version of one of these should work: http://gopro.com/ There were several aircraft on static display at AOPA Summit with GoPro cameras mounted in various locations. There is also a version o
I'm ready to buy. Best regards, Rob Housman Irvine, California Europa XS A070 Rotax 914 Airframe complete Avionics a work in progress All...please contact me if you have any interest in ordering a se
Here's some more info on Tempur-Pedic foam. http://en.wikipedia.org/wiki/Tempur-Pedic . Best regards, Rob Housman Europa XS A070 Rotax 914 Airframe complete Avionics a work in progress From: owner-eu
I must take exception to the part about "...make the pin insertion and retraction very stiff." In my case the word "impossible" is substituted for "stiff." The "dummy" in dummy spar is the builder wh
I suggest that you re-think your sequence. Perhaps you scheme will actually get the tank clean but since both acetone and isopropyl alcohol are polar solvents they won't do a thing to remove oils whi
Do you have a version of this file that can be opened in SolidWorks? Best regards, Rob Housman Europa XS A070 Rotax 914 Airframe complete Avionics a work in progress If you have sketchup, you might w
Assuming that I am not the only one foolish enough to attempt a retro-fit of Mod 76 (Dynon) to a completed airframe I would appreciate any help from others who have done so. I am currently at an impa
Thanks Ron; all good suggestions but unfortunately none is suitable. See the attached photo and you'll understand why. The perspective is from the starboard side looking through the opening for the s
OOPS, that's from the PORT side. Best regards, Rob Housman Irvine, California Europa XS Rotax 914 S/N A070 Airframe complete Avionics in progress Thanks Ron; all good suggestions but unfortunately no
Nigel: What you describe is almost exactly how I connected the port and starboard pitch push rods to CS10/2, the only difference being that I did not need to magnetize the socket. Both of these conne
UPDATE: Before removing CS10/2 I tried once more to get the offending nut onto the bolt with the assistance of my son's slightly smaller hands. Success! Once the nut was aligned with the bolt I could
I do not have an extra CS36, but since I had to fabricate one I can provide a SolidWorks solid model and Alphacam CNC file for your use, if you have either a machine shop or a friendly local machinis
Good question, Will. I too have contemplated what to do about the gaping holes for the rudder cables. I have yet to come up with a solution, though perhaps a modification that uses a short push rod i
Having recently done the retrofit of the Dynon servos (very similar to TruTrak) on my completed tri-gear airframe I have a few tips to offer. In fact, I attempted to post the tips to the forum about
I don't care what these clowns "proved" in that video, it is not supported by the science of heat transfer - at the rather low temperatures encountered in an air to air intercooler the dominant modes
Mine are 1.25 inch diameter, but I think earlier kits had a smaller diameter. Best regards, Rob Housman Irvine, California Europa XS Rotax 914 S/N A070 Airframe complete Avionics in progress I'm just