Tony I have the following measurements for you, Floor to top of stick 530mm, top of thigh support to top of stick 305mm, stick fully back top of stick to top of back rest 580mm and stick fully back t
Hi Tony That was quick let me know if you want any other dimensions. The Europa build in England is only approved using SP Gurit Ampreg 21 which replaced Ampreg 20 in 2010. According to an Ampreg 21
Hi Paul Try and have a word with Andy Draper at the LAA office Richard Hi All, Just getting the pitot system installed & am wondering where the best place for the 2 static ports should be? Ive alread
Alan You can have them re-pressurised by the original supplier, Industrial Gas Spring Ltd, 22 Wates Way, Mitcham, Surrey. CR4 4HR. Contact James Godbold Tel 02086466594 email james@igsltd.co.uk. Mine
Hi Mark Very well done, now the fun starts. I=99m in Sydney in February, where is Qld? Regards Richard G-CGZV I=99m proud to say there is one more Europa in the sky. It tends to drop the left wing wi
Hi Paul I just polished off a little bit of overspray with T-cut. Try and practice on a bit of offcut first then mask up so you create a good sharp edge and polish away. Best of luck Richard do not u
Hi David How much do you want for it? contact me off line on 01327 260045 or rcollings@talktalk.net Richard I have one of Bud Yerly's 70mm fuel caps excess to requirements. Will accept something near
Hi, I might be able to help, contact me off line on 01327 260045 or email rcollings@talktalk.net Regards Richard G-CGZV Europa XS Tri-gear --Original Message-- From: hanaperrod Sent: Monday, January
Hi Paul Use a short length of tube with a larger diameter than the lug as a reaction point on the back face of the prop flange to allow the lug to be drawn into position using a threaded rod with pla
Hi Gilles & Brian Watching your email thread I would like to add my 2 pennies, I was aware that there was a problem with exhaust gasses entering the cabin through the flap slots on each side of the f