Hi! Fred My oval hole cut in the tank top is protected by the plate internally and a silicone seal round the edges and I have had no problems of the swelling kind except I had a leak once from the pr
Hi! David . Sorry you didn't make it but why not a weekday ? Regards Bob H. Just to say that' S*d's Law was in operation on Sunday. In the middle of the best Wx the UK has seen for months, possibly y
Europa original torque tube and clamps ( pre the latest Europa re-design of Torque Tube arrangement ) I have been approached for some more torque tube clamps. Since the last batch has now been moved
Hi! Steve, It will be unusual if I don't come however due to some fluid personal situations I can't yet declare when or how I'll be there ! When things crystallize I'll advise. Regards \Bob Harrison
Hi! Colour chart here:- Mine was actually Cobalt Blue.:- www.goldburnfinishers.co.uk/ Also:- www.accoatings.co.uk/who are in Birmingham ( I think they were the outfit that "supplied only" my paint, a
Hi! Guys, Further to my message below I should also tell you that I also do an annual wipe out through the large oval hole in the middle of the tank top which contains the fuel level sender where I c
Hi! Goff, Further to previous posts I'm pretty sure I will attend although things are a bit fluid at this end. The plane is ok after I found a No 4 bottom plug lead off, a month ago it was No. 3 so I
Hi! Andrew, The washer/washers are bedded to take up any slack on the back of the starboard spa tip and canister So contributing to retaining the Starboard spa close secured to the Port Spa. The Star
Hi! Just to be helpful........I can confirm that the weather here is hot and humid with wall to wall blue sky.........what is it Cavok...... Regards Bob Harrison G-PTAG
Hi! All/Graham,/Roland Fuel system sealant. Yes, Graham is right , Hylomar is a product made under licence from Rolls Royce who developed it, I worked there and it was mandatory . However it only req
Hi! Tony . There is a position to the side of the rocker box which is dry ( no coolant and no oil to receive the sensor which is not unlike a little cylindrical sensor definitely NOT an under plug se
WELL DONE MANFRED < Congratulations ......now you will find it is real. Best regards Bob Harrison G-PTAG Kit 337 ....1000 hours plus. Hallo, to the group of all EUROPA enthusiasts on this forum . I'm
Hi! All , I think it more than appropriate that I should seek to advise all Europa Owners that a later version of the Torque Tube original clamps is now available for interested Europa Owners to enqu
Max.......Further to what Bob has said I recall my last solo circuit before my Skill test at Ormond Beach Aviation when I was allocated a Cesna Aerobat and hadn't noticed the flaps were by a switch n
Hi"! Alan I'm sure our club will welcome you . It isn't actually always easy to access the web page but be sure to use :- http://www.theeuropaclub.org/ It works because I have just proved it . Best r
Hi! Carl, On the contrary, your comment about the LAA may just be relevant since in my opinion they should be able to bring pressure on the new owners (Swift Aviation) of the Europa Company to resear
Hi! All, It seems that we Private Pilots aren't the only ones to make errors !!!Must have had his GPS turned off ? Couldn't have been using Sky Demon anyway ! Regards To all. Bob Harrison G-PTAG From
Hi! The next time I clean out spats will be the first .....other than doing tyre changes. The only problem I have is that without spats the underside of the wings are always covered in shit. With reg
Hi! For the attention of Rowland.... I have been away so couldn't answer your request earlier. I used Nextel Cobalt Blue which is very serviceable in that general finger grime does not show up either