Curtis, Try my broker at http://www.wenkinsurance.com/. I believe that there are 2 underwriters that still offer it. Its not cheap though, around 1250 for hull not in motion and for me around $2500 f
Hi Craig, UMA sell a differential pressure sensor and gauge for the fuel pressure. It was developed in conjunction with Europa Aircraft. I assume that it is still available. I have one and it works w
Danny, I attached mine to the rudder also. This is done on some production aircraft as well, (Mooney I think) so I can't imagine why your inspector has a problem with it. Take a look at http://europa
Hi all, After flying my mono wheel for 340 hours with various C of G's and weights I an still surprised at how differently the aircraft behaves on landing. I find that the amount of power needed in t
Mike, Many people, including myself have discarded them. I put a heat box on the firewall and brought the air in through the panel. It works okay, quite frankly it would work much better if I could c
Hi Bruno, In the US the builder is responsible for stating the operating limitations for the aircraft. Based on Andy Draper's advice I made my operating limitation to be a MAW that would ensure that
Patrick, I would start with replacing the regulator, these can be pretty troublesome and it they are not kept cool tend to fail pretty often. Paul N378PJ
Guys, I believe Dave Anderson set something up for his motor glider. He was trying to prevent a cold slug of oil going through his system when he restarted the engine after an extended soaring sessio
Hi You need to make new spacers 1.7" long, the tube will need to clear 3/8" (mine was .336 ID) bolt and the OD is .500. I think I got the tube from AC Spruce Paul
Hi, I used the factory stuff on the stabilizer and fuselage, but Superfill for the rest. I found the Superfill easier to work with, but at the end of the day its the technique that you use that makes
Jeff, I made a simple whip antenna that went in the back, against the D section. It pretty well followed the line from the bottom of the D to the top section of the fuselage. I can't remember the len
Hi all, For the last 30 or 40 hours I had the orange boost light come on at power up and if I recycle the power it goes out. The manual doesn't give much of a clue, has anyone had any experience with
Danny, I heated up a bit of rod and pushed it through the blue foam. I then drilled a small hold in the back of the rudder to pass the wires through. Paul
John, If your talking about your transponder antenna then I had to move my transponder antenna from behind the bulkhead. I had a spike antenna mounted to a 150 x 150 ground plane, but I would often g