Hi all, I just received the kit from Europa today to connect up my manifold pressure gauge. I have just finished connecting it up and I must say for those who have a need to penetrate the firewall th
Hi all, I might do some experimenting I the near future to see if I can measure the fuel pressure on a 914. The idea was to have two transducers, one the air-box and the other on the fuel line and me
Hi all, I have to drill the tail wheel spring and I must admit to not looking forward to doing this with a hand drill. I am assuming that the spring steel will be pretty tough going. I was thinking o
I can come to have a true respect for the expression 90% done, 90% to go. I sat down Sunday night to list off some tasks to do during the coming week. In about 5 minutes I had an incomplete list of
John, Take a look at http://europa363.versadev.com/ under July 20., 2002 and you can see what I did. I don't show it in my photo's but I have the vent coming out of the side of the aircraft near the
John, I used the drain valves from the factory mod. I have mine fitted beside each other next to the gascolator so I only have one place to go fro me preflight checks. I have a few photos on my WEB s
Steve, I put my Bob Archer com antenna in the vertical fin. It was a tight fit but I managed. I have since found out that he offers a model where the top & bottoms of the "E" swing which would have m
Hi Paul, couple degrees off but that was enough so that when the came down the outriggers did not fully deploy which left them as a hazard to retraction I'd be interested to know how you adujsted out
Hi all, Is anyone out there using one of these, or are most people using the EIS 2000 ? I have just upgraded mine to the 4000, mostly because it offers 6 auxiliary ports instead of 2. In addition it
Hi all, I am installing a GX60 and I seem to recall a minimum size requirement for the GPS antenna, however upon scouring the installation manual I can't find a reference to this. Has anyone out ther
Hi all, Can some one suggest a US based mail order house that would sell 1/8 NTP taps. I can't find them in AC Spruce and the only other tool supplier that I use is http://www.use-enco.com/ and they
John, I ordered some today, thanks for you help. I was wondering if you had any more photographs of how you mounted your landing light ( other than the ones on the Europa USA site) I think I will cop
Hi all, I fitted my out riggers today and I found that the wheels are 30mm off the ground. I suspect that I could sneak a bit on both ends, but not a lot. I'd be interested in knowing what are the ty
Hi all, I can't seem to find where in the manual it explains on how to go about doing a weight and balance. Can some one direct me. I did a very quick measure today and it looks like I have about 780
Hi all, Well I actually cranked mine up and taxied it around a bit on Sunday. Most everything worked except for the alternator charging. Mine idles at around 1800 rpm and at that engine speed the air