Hi Jeff The A side of the pressure switch will operate as a stall Warner ( Negative pressure) The B side could be used ( positive air pressure) to operate a flight timer or to switch on a transponder
Mine extend 3/4 inch from the doors both ends , 952mm is nearly 37 1/2 inches? In metric the shoot bolts extend 19.06 mm Ivor Phillips XS486 London UK CM Installed, rudder cables complete, undercarri
Brian I purchased one at Flying for fun in july, The latest versions will now track 12 satelites instead of 8 and have a larger database card, Not sure about a replacement being in the wings Ivor Phi
Laddingford is 51` 11.48 north 000`24.90 east Ivor Phillips XS486 London UK CM Installed, rudder cables complete, undercarriage fitted brakes working flap tube fitted wing lift pins fitted,tiebar fit
Ian The seals for the parking brake and callipers are readily available, I have six complete sets sitting on the shelf, They are just O rings If you specified EPDM rubber for DOT 3/4/5.1 Or Buna n ni
Patrick It would appear to be plain automotive carb cleaner, The one i use is STP and works really well, Easily obtained at most car accessory shops B-12 CHEMTOOL CARBURETOR AND CHOKE CLEANER / PROFE
Its worth the read Ivor Phillips XS486 London UK CM Installed, rudder cables complete, undercarriage fitted brakes working flap tube fitted wing lift pins fitted,tiebar fitted instrument panel being
Anybody using the Rotax engine cooling air baffle (975796) on a 914, And if so did you have any appreciable drop in cylinder head temps, Also i believe that sealing two of the four top cowling slots
Hi on my pumps made by pierburg, The small terminal is Positive + and the large is Negative - polarity is important but I can't find anything in the manuals about electrical polarity of the pump term
I used MS21251-B3S turnbuckle body X 2 ,MS21255-RS eye end X2 and MS21255-3LS eye end X 2 And not forgetting the four locking clips MS21256-1, Use the normal AN 100-4 thimble with the stainless steel
I have one and will use it as a back up Emergency Radio :-) Only Or until EASA allows its use Europe wide, But don't hold your breath!! Even though it is certified in Finland. I will also have a cert
Hi peter Buy a good quality ethylene glycol antifreeze, Bluecol is one, But mix it with distilled/demineralised water, A good source for this is from a dehumidifier, Ivor Phillips XS486
Hi Gary I used a Andair FS20X2-F fuel valve, Off to the Right, Main straight ahead and reserve to the left, The return fuel from the Rotax 914 regulator can go back into the Reserve side of the fuel
I used exactly the same on my pipe fittings, All Metal with DOT5.1 Glycol base Brake fluid, Been Working fine for the last year, No leaks and fittings in the right place regards Ivor Phillips
Happy new year Ferg I will admit that the correct bolts appear to be too short at first! But with a bit of persuasion they will fit, I too used the cut length of studding to compress the Lord mounts,