Ken, TCP is now getting back into manufacturing. They changed mfg. locations and had EPA problems but now solved, and laboratory testing at a new co. which is now finishing their first batch of about
Ferg, I am trying to get into the club website but I'm not there yet. Do you have a description of what this mod is? Do you have any pix of the change. I've got 28 hours on my mono-wheel and I would
Tony, Sit in you seat and you may find that the shorted length needs to be on top. The offset needs to clear the seat and your lap. Then into your stomach!! Remember that the stick pivots way down an
Hear Hear! I don't believe any one (except Van's I'm told) can so what we can. Hav'nt seen a video where he shows what it can do safely. Ours is tried and proven. A caviot to this, the tri-gear was n
Thanks Andy, I wasn't aware that it had been done. You are the first person to say so. I had heard that it hadn't been done. So the comment! I do enjoy the mono-wheel. Jim Nelson N15JN
William, Just reverse the mounting of the lift strut. You mount the cyl. to the fuselage near the top of the fuselage door opening and mount the cyl to the door about 9" down the door (from the top).
Sounds complicated to me. Just use fire resistant ducting as you would in any cert. aircraft. I have a fire warning system under my cowl t assist in determining if that is a real threat. Jim Nelson N
Tim, I replaced the 2" angled piece with an aluminum tube with a 2" thin wall O.D. Cut it to match the angle required to mate up with the filler and made it about 1/2" short at both ends. I then used
Dale, The mod works for me. It seems that there is a mod that utilizes some type lever arrangement that uses the lift cyl. Haven't seen it but it might be very good. My mod is from a change that was
Ferg, I have the aluminum tube to replace the rubber angle tube on the fuel filler. I used the PVC tubing to attach each end of the alum.tube. I've had it in operation for 6 months now with no indica
Bruce, Any thin aluminum tubing works fine. The thinner the better as it all counts up in weight. You can get some tubing from Aircraft Spruce or your local aluminum welding shop. Just get about 18"
Richard, Where did you get the spare parts to fix your nac vent?? I also had a vent stud break off so I want to fix it. At this point, I have put the ramp back into the unit and used some blue foam t
Ferg, I have the aluminum angle piece with PVC tubing at each end to hook up the system. I've run auto fuel for 6 months now with no effects to the PVC.
Tony, YES YES YES!!!!!! There will be fuel vapor coming out of the plastic. Jimmy Thursby tried it and got "burned" for the effort. If you fill the tank completely with water you will stop most of th
Tony, Just elevate the stock shoulder harness attachment above your shoulders. Actually I threw away the Europa units. I purchased a set of Hooker Harness for both sides. I preferred the military sty
Hi again, If you talk to Hooker Harness they will have my dimensions. The only caveat is I had a long hookup for the shoulder harness. I purchased inertial reels with my units. If you attach the iner