Jim , might join you if I can get my jobs done. Dave Dave Park to the Scilly Isles (208 nm) and back in a day from Membury. I've got the PLB and life jackets, so I'm all set for the trip. I just don'
Carl, Likewise I have a 1cm gap between bottom of water radiator and bottom cowl. I experienced heating problems on the ground in Spain on recent trip to Gibraltar. I will be experimenting on my next
COOLING FAN FOR GROUND COOLING. Has any one experimented with a fan? Dave Park the moment. be very helpful. have the 13 row oil cooler too, but the builder had it mounted with a 30 mm gap between its
Three nights would get you to Segovia and back if you want to join the Spain trip which is now provisionally scheduled end of June? Dave Park or Spain. Sounds like its too short for you marathon boys
Was the XS Fin offset? Dave Park the engine call for the 4 washers on each lord mount to be arranged so that the engine is angled 1.5 degrees to the right. straight ahead. What effect will there like
This is from the Rotax Installation Manual. Dave The engine mounting frame has been designed with the engine offset to the right by 1.5. To check that this offset is correct, clamp a straight edge to
http://www.europa-aircraft.co.uk/parts/upholstery.php Dave Park e reason I ask is that I too am ready for interior and am just putting it of f really. I had two brothers from a local trimmers come to
Karen, Regards Dave Park kind words. It is not often that I comment on subjects, but on this occasion I feel I need to advise of the situation regarding the Gas Struts. The gas struts supplied by Eur
Carl, Converted my mono to trike two years ago and fitted springs with help of Neville. Unlikely to fail and more or less a permanent fit! Handling no problems. Dave G-LDVO Dave Park but I also have
Jon, I flew back from Spain and on landing back at Sleap i later found three springs broken. ???? Carry spares now!! Dave Park a spring loss on my Classic exhaust and there has been no side effect, s
On older pipes with upturned hooks you need 95mm springs available from CKT n ot sure if Europa has these? Regards Dave Park e springs, and failures result. This is especially true for the 912S and i
Hi Graham, I built the Mono G-LDVO as i was looking for efficiency and speed for tourin g which is what the Mono excels at. I converted my Mono to Trike after a near crosswind event which almost took
If the installed fixed nut became loose then the fixed nut could be installed higher up in the footwell conventionally attached to a washer bonded to the inner footwell wall out of the way of the rud
During build do it as in manual. I was only suggesting a possible maybe better repair if the imbedded anchor nut fails. It will not take much torque when tightening bolt? Make sure bolt thread does n