Hi Ferg, I had the same issue but decided it was OK because the hinge is bonded to the tang. The load is spread across more than just the area of the nut. Brian Davies kit 454 holds
Dave, I have installed isolation valves on the tank side of each filter. I e mailed Francis Donaldson asking if a mod had already been approved for this and he did not answer the question but suggest
Hi Mike, I would not use the trailing edge of the fin as a guide. You can always cut this after bonding to get a straight line. I found that more overlap was possible if you pulled hard and slightly
I have just purchased the Skydrive Coolant Carburetter heater CH-912-3. I see --From the instructions that this requires PFA approval. Is there a standard PFA mod number for this or do we have to app
Hi kevin, I am still a builder but have had chance to do a bit flying recently (thanks William!) and the pitch trim is sensitive. The trick seems to be to "blip" the switch for a very short period of
I have used a Skyforce GPS for many years and have been very happy with it so I have designed one into my panel- but I have delayed purchasing one until now. Does anybody have any industry knowledge
Mike, If the NACA vents have an adjustable flap they are meant to be fitted forward of the door opening and roughly 3 inches below the fuse join line, although I have seen them in varying positions.
Steve, I have just followed your instructions and get the same problem previously described- I just end up with a small logo in the top left corner of a web page after download. urls.
I searched for some standard Ampreg late this year without luck, and then tried Europa- they delivered it the next day! Brian Davies kit 454 Paul I bought some last year from Aquafax Ltd, tel 01270 5
Good point John, although I would not think it would be necessary for an aircraft installation. Brian Hi Brian that One in Penetrox preparations prevent systems and for a --
Having finally finished the construction (but not the paperwork!) of my Mono XS 912S I am preparing my trailer for holding my pride and joy. I bought the very last Mono enclosed four wheel trailer ma
Light Aero Spares sell the equivalent Deoxidine 624 aluminium prep and Alocrom 1200A and 1200B in one litre bottles (two part pack) . I used these products and they are Ok. Tel 01837 658081 Alocrom i
G-DDBD took to the air for the first time at Blackbushe today, in the = very capable hands of Pete Jeffers. =20 It flew well, requiring no major adjustments so far. One or two minor = bits to adjust,
Ron, The rear bulkhead and tower are much easier by splash. There is a bit more space for working on the baggage bulkhead and you can also fit it at a later stage. Brian Davies Wondering if I could g
I did not send form Sf16 and my paperwork was cleared, so it would not appear to be required. Brian Davies A question for all the uk flyers here. I've been looking through all the various forms that
Hi Bob, SF16 is a PFA form available for download from their website, which appears to be like a mod approval form. Look under engineering standard forms. I am not an expert in this area but I assume
I wish I could join you David, but I am still waiting for my permit and dont have the skills to fly the aircraft (yet!) maybe next year. Have a great trip. Brian Davies The Tour de France will be fro