Dear Tim, These radiators are still available through the factory if you are unable to find second hand ones. Please refer to the catalogue. Regards Andy After bursting the Rotax 912S into life it ap
Dear Paul, I have a sheet detailing NACA scoop installation that should have accompanied the parts. Please let me have a fax number and I'll send it straight away. Regards Andy I know there has been
Dear Paul, I have details for this that are going out in the forthcoming newsletter. I'll fax this at the same time as the NACA stuff if you wish. Regards Andy Having brought the pitot/static lines b
Dear Paul, The recommended method for supporting the aircraft off the ground to do the gear retraction check is to use an engine hoist and lift (using ropes) from the landing gear frame where the upp
Dear Jim, When I did the flight testing for the speed kit on the mono-wheel, I was careful to conduct the two comparison flights (each with at least 3 speed runs each way) within an hour of each othe
Dear Thomas, It's great to hear that you are due to close the circle. Good luck and safe flying. Best regards Andy Draper Dear fellow Europeans ! After having crossed the Atlantic Ocean and the Pacif
Dear Tim, Many congratulations on getting your Europa into the air (and back down again). I wish you all the very best and safe flying. Don't forget to check and clean those filters regularly before
Dear Sven, We tried the IVO PROP on G-YURO with its 912 engine and the performance was notably poor. The cooling efficiencey on the ground also suffered. Unless the prop has changed radically in the
Dear Paul, There is a limited number of the static probes in stock in the UK. Cost is 3.34 pounds plus P+P. Please let me know if you'd like to order one. Regards Andy Hi All; I searched archives for
Dear Steve, We originally had the static probes made from aluminium, but found that it was difficult to avoid a burr around the small hole where the drill breaks out. You cannot have a chamfered edge
Dear Jos. I'm sorry if you have been ignored. It's nothing personal. I'm not aware of you outstanding order (wrong department), but I'll ask for it to be followed up. Your request for a static port i
Hi Duncan, The IVO prop was a VP version, using a rod within the hollow blade to twist it at about 70% radius. We found early on that it was poor so it was abandoned. Regards Andy Andy, Did you ever