Wing seal tape is available from: Bolus Maxi Tape P.O. Box 221 St Paris, OH 43072 Or e-mail Mike at: usoar@juno.com Yes, white electrical tape will work, but it leaves a, yellow, sticky residue, espe
Greetings all, For quite some time now I've been working towards getting my top bonded on. I've been trying to think of every conceivable task that needs done before the top goes on in order to limit
I went ahead and cut the reinforcing triangles out and after trimming about 1/4" off on the top where the resin on the bonding flange was a bit thicker from the molding process. These areas needed to
Greetings all, Just wanted to report that A-245 now looks more like an airplane than a canoe. After months of prep work, with the help of a few friends we bonded on my top this morning. All went well
The Delphi unit's antenna will fit above my overhead console with the plastic case removed. There are other antennas that will also fit here. I tested it and it receives just fine through the skin. T
Greetings all, I've started the task of installing my sternpost and I've noticed what I believe is a gross error in the alignment of the rudder horn. I cut the base of the rudder exactly as it is sho
Greetings all, I thought I'd chime in here since I just finished my conduits. What I did was make a mold using PVC pipe, actually about quarter round of a 2" PVC pipe. I cut the PVC lenthwise in half
Hi Bob, "E" Glass is single weave with the fibers oriented at 90 degrees to each other. When sandwiched with 'Bid it gives the part fibers which run at 45 and 90 degrees to each other. It's available
LINK_TO_NO_SCHEME@matronics.com, BODY:, Contains@matronics.com, link@matronics.com, without@matronics.com, http://@matronics.com, prefix@matronics.com Hi Nigel, Thanks for your input and obvious vast
Greetings all, I was wondering who folks are using for seat cushions? The upolterer John Hurst has been using contacted me about three months ago and said he'd send me fabric samples, but after sever
Greetings all, Although I've only had one flight, about an hour, behind a Jabiru 3300 fitted with an Airmaster, that being Andy's J400 Demo, I would have to agree with Andy from my observation that t
Hi Jeff, I did my interior with silver-grey Zolatone and it looks great! No priming is needed on fiberglass according to the manufacturer. It took a gallon, plus about a pint to do the entire cockpit
For the Tri gear builders, how have you closed the front opening on the bottom around the front wheel. I know the opening has to be big enough to withstand a 2" in the front gear but how have others
Hi Guys, Sorry, I should have mentioned that I do intend to line the area in the tunnel forward of the new bulkhead with fireproof insulating blanket in lieu of the stainless firestop, along with the
Over time, unsoldered, unprotected crimped fittings will eventually corrode. I've seen it over and over in the field. While > this may not be a huge and Battery lead crimps are better protected over