Al, You will have to continue working with the top hinge supports of the door. As I recalled I had the same bow in the front edge of the door that stuck out. I had to shim with washers at first under
Still looking for anyone that's painted the Europa before to give me an estiment on how much used. I have the primer Im just looking for the amount of paint. Thanks Jeff A258
I am one of those that has purchased the expensive key switch with both mags on before contact. After reading this I'm wondering about going the inexpensive way and sending it back. Anyone else out t
I am with this Idea 100%. I am nearing the end of my build but I know if it was me on the other end of the stick and lost every penny I saved for this dream, I would be devistated! Not to mention wha
Hi all you Europa crazies... Me Too! I am close to ordering a Dynon for my bird but I have spoken with 2 people (RV Builders) that have talked to other people with supposedly bad experience with it.
Cliff and all, Thanks for your responses. I will be ordering the Dynon. It seams as though vibration is the enemy so a softer mount for the front panel plate would be smart. In any case thank for all
Fred, Just sand it to where there is no shiny material left. You shouldn't have to sand into the glass to worry about degrading the material but even if you get into it a bit you are about to place 2
Svein, If I had to do mine al over again I would not have used the splash molding to make the NACA vent on the top. I would have like others brought the intake air up from the bottom NACA inlet that
I have changed my mind and have decided to sell my Navaid Device / Auto Pilot. It is brand new and has never been installed. Still in the box as they say. Anyone anywhere please contact me off list i
I would like to know what others have done with regard to walls and doors for the interior. I been told by a local Long EZ builder that the proper way to go is with Zolitone. I can only find it being
Best ask the guys that used it, but I'm told you spray it with a HVLP gun. Thanks to all for your responses! You all are great! Jeff A258 Starting to see some blue light at the end of the tunnel.
Kevin, The following is the way to go and I recovered it from Nev, after I was far along via the manual and had made many mistakes. Take 2 or 3 inch 2 sided masking tape and tape it around the recess
Before the factory web site went down there was a picture of what I think was the new interior of the USA demonstrator, but I'm not sure. It was a very bright red white & blue leather as I recall. Is
Thanks Alan, I really don't remember. I think it may have been in the builders link but I'm not sure. I remember someone here talking about that new interior on the demonstrator and using the Florida
Sorry Svein, I meant to say from the flange as Andy indicated. I just measured mine and it's 5 mm from the spinner to the cowl. It's a little tight when your removing the cowls but the fit looks real
Hi Paul, I used 180 grit to rough all jell coating before primer. Can't say how the paint looks yet but the primer then was final sanded with a 400 grit and it looks great. Jeff A258
Sorry Richard, You may be right by what might follow in a court of law, should Mr morgan take it that far, but your comments of how life is a bitch are very much incorrect in my book. Good things hap
Understood, but the point is that suppliers are companies not customers. These people have in some cases used hard earned savings or even financed to obtained their dream. Satisfying these people sho