Hi Jeff,
The idea of putting a lot of heat in that area could cause problems. If you need
to remove the bearing I would try and find a way of putting localised heat on
the bearing to soften the loctite then pulling off the bearing.
An electric soldering iron either attached to or kept in contact with the flap
tube will provide ample heat without risking heat damage elsewhere.
A good blob of solder on the tip will provide a good thermal contact.
If you can attach the iron even better, you will have a free hand.
Good luck
--------
Europa mono Nr 192
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=503368#503368
|