Hans-Peter Reusser wrote:
>
>Hi Bob
>
>I would be very interested in a copy of this 8 pages of how to do it.
>I'm presently trying to manufacture some lenses as well.
>Could you send me a copy to my private e-mail ( hpreusser@tiscali.ch ).
>Best regards
>Hans-Peter
>
>
>-----Ursprngliche Nachricht-----
>Von: owner-europa-list-server@matronics.com
>[mailto:owner-europa-list-server@matronics.com] Im Auftrag von
>R.C.Harrison
>Gesendet: Dienstag, 6. April 2004 01:19
>An: europa-list@matronics.com
>Betreff: Re: Europa-List: Vacuum Forming Perspex.
>
><ptag.dev@ukonline.co.uk>
>
>Hi! Duncan
>This forum is the most amazing source of information .... within two
>hours
>of my message going out a kind chap at Boeing "patched" me 8 pages of
>method
>and temperature suggestions! Should you wish I can send it through?
>The Air World one stands too high to get into my trailor safely and has
>a
>different base, the existing Gold Wing one needs to be only about 1/4
>inch
>higher to be futher away from the heat of the bulb.
> I've had a female plug roughly cut in aluminium but have a lot of
>"burring"
>to do to get the final shape cut out then I was going to try the vacuum
>thing. Just skip reading the 8 page detail above it could be possible to
>do
>with some combination of methods.
>regards
>Bob H G-PTAG
>
>
As would I, if it's not too much trouble. I'm a sign maker, by trade,
and have lots of plexi and poly carb at my disposal. More than willing
to share with anyone in need...
--
Jeff - Tri Gear
N55XS
|