Once you have done the simple vertical cut, this may help you shape the tip
itself...
Draw a horizontal line along the centre of the piece.
Draw a horizontal line between this centre line and the top surface to divide
the
vertical face in two.
Draw a line on the upper surface to again
> After trying all sorts of fancy tricks to ease the (admittedly
> minor) task of plotting out the airfoil shape to cut out the tip of the
> horizontal stab (including an inconclusive bout with AutoCad), the light
> suddenly dawned:
>
> Just stand the _tip_ end of TP1 on a sheet of paper and trace
> around it. Cut out the resulting template, and you can use it on top and
> bottom of both horizontals.
>
>
>
---------------End of Original Message-----------------
--------------------------------------------------------
Date: 11/29/96
Time: 08:33:18 New Zealand Summer Time (UTC +13)
Kaon Technologies - Building Tomorrow's Networks
PO Box 9830
Newmarket
Auckland Ph +64 9 358 9124
New Zealand Fx +64 9 358 9127
Visit http://www.kaon.co.nz
--------------------------------------------------------
|