Greetings: My Port side Mass Balance holes in the wing bottom are not aligned properly with the indention's made at the factory. The root end hole is almost exactly centered but the tip end is agains
The cure is to cut the top off the horn close out box so that it does not push the top skin up due to missalignment. After bonding on the top skin you can replace the horn close out top with a bid la
Brian I had a similar problem with my XS wing. Owing to a manufacturing fault the foam cut-out for the mass balance horn nearest the tip was not in the right position. I considered briefly whether to
Brian - I found that in my starboard wing (only one I've tackled so far) the indent did not line up with where my outboard aileron horn actually was. The word from Neville at the factory was to move