Hi Roland, I would like to have a look at your problem. It's only a 10 min flight from EDLM. Will you be at the airfield on Sunday morning (if it's not below -5). Best regards Barry -- Barry Tennant
Barry, I left a message in your private box. Raimo, check if you need to calibrate your ASI :-) Roland Read this topic online here: http://forums.matronics.com/viewtopic.php?p=365793#365793
Roland, I have calibrated it carefully. Flying a triangle and counting an average speed. Or flying when zero winds and compareing to GPS. Also, I give my panel when new to The Finnish Airforce=B4s Te
Raimo, I'm afraid my bird cannot compete to that numbers. Tango India isn't slow (about 125 KIAS at 4800 RPM, don't ask me for MP, burning approximately 20 litres) but it is a Trigear albeit equipped
Kevin, I was sure somebody will pick this jerk. Good. No, it flies direct. Me - a stupid first time builder - understood to assembly the balls (Dynon and conventional) perfectly direct to the panel.
Roland I have to say I use typically 5000-5200 revs and also I am not shy to use constant 5500 rpm. When low, it shows if I want a manifold pressure 30-31 In hg A (912S). Typically my MAP is around 2