"Electrolysis" Because of it I had to replace my Pitch Push Rod:- During assembly of the Rod End Fittings (Steel) to the Push Rod (Aluminum) I made the mistake of liberally coating the inside of the
Troy, Removed the push rod containment lower bulkhead, disconnected the push rod, and slid the rod out through the wheel well, obviously no landing gear in situ. Peter Classic #198 Filling-Sanding-Fi
Hello team, Anyone had any dealings with Andair? Ordered and received Fuel tank selector and Gascolator etc, very nice, but find a few parts missing, send several quiries to Andair through Owen Phill
Hello team, Ordering another part seems the way to solicit a response. I attach the reply I received from Andair. Regards Peter Peter, Thank you for your on-line order. May I also apologise for the d
or perhaps Perhaps like me, have been staring at one in their hand trying to think of a fix, your comments on this idea:- Turn down a step for a distance of a 1/2" in from the end part of the Connec
When I purchased my Kit ( oh so long ago ) was advised by the oracle himself to request the Aircraft manual and pre-flight check list when approaching the end of the building stage!?!?!?! But I don't
Spoke at some length a while back to one of the head chemists in a major company in this country that produces a broad range of Epoxy's etc and asked him specifically about the expiry dates and there
I done the mod in situ prior to the top half of the fuselage being installed. Using a 9.5mm drill bit which my callipers showed was just a "fraction" smaller than a 3/8" bit that was called for in th
In the Catalogue ACS under Hardware (HA) look under Cherry N Rivets, about 2/3rds down the column under the heading Cherry N Rivet Identification Code is all the information you need, in my book it's
I rod. The set angles of the Flap Push Rod are not cast in stone, you can make adjustments, I did so as I have made and installed a mud guard. Peter #198.
Section 21 of my manual doesn't make it clear, so I am assuming that when fully balancing the Tailplanes I must disconnect the Pitch Push-rod from TP9 thereby balancing the Tailplane only and not the
Use beer cans, when empty flush out, run a sharp knife round the middle leave to dry.Instant one shot mixing cup, ok a bit rough edged can clean up with scissors if you want. To get you started get