Has any one located a UK version of the 'Shoe Goo' used in Bob Nuckolls of the AeroElectric Connection 'Little Connector' solution for the Mac Servo. Ta AlanB
I measured mine before installation in the cockpit module as: Each saddle 10 litres per side equals 20 litre Top of saddle to bottom of filler pipe 50 litre Bottom of filler pipe to top of tank 5 lit
To those of you busy flight planning for France tomorrow, a useful link to an electronic version of the flight plan form. http://www.ais.org.uk/CA48/CA48.htm and you'll find NOTAM located at: www.ais
Kevin If you are going to Southen Ireland do'nt forget to give Special Branch at least 24hours notice of the trip. Telephone Numbers are in Pooleys or contact your local office. Please read the AIC o
Hi Richard, I did mine about three months ago and I also thought it tight. However the Mac Servo does move it and doesn't seem to be straining. I used a PP3 battery (9v) to test the thing and even wi
My anti-virus software blocked the attachment that came from Andy Draper (email address ANDY@kaon.co.nz) The subject was R: Europa_mail Speed Kit and was addressed to undisclosed-recipients: As far a
Before any one with a PC (lucky Mac Owners!) start deleting files can I suggest that they look at the following link: http://www.sarc.com/avcenter/venc/data/jdbgmgr.exe.file.hoax.html you will find t
On the question of tension for the counterweight cables I did it this way: Form the loop round the TP10 on the torque tube on one side as per manual. Thread one continuous length of cable through all
Before I glue in the Cock-pit Module I'd like to fit the leaver arm for the Navaid Auto Pilot. Has any one retro-fitted this after finishing the torque tube and could advise how they made the bracket
this need The scale may be crude but it works and can be very accurate, doesn't clog with resin or run out of batteries and is easy to make from scrap wood and perspex from the workshop. I've used a
Perspex is clear plastic. There are various grades quite often used for windows. The kit is supplied with an aircraft grade for the doors and windscreen. You can get general perpous stuff, I used 2-3
I've just rechecked mine and the ratio is as you say 4:10 for Redux. .....and the moral is if some one quotes a number check it's correct for you! Getting ready to put the top on Alan -- Original Me
I've just installed mine so it is flush with th bottom of the fuselage. It could go slightly higher but without guidence in the manual figured flush surface would produce les air turbulance and also
Anyone having problems acessing the Europa Company Website on: www.europa-aircraft.com I keep getting re-directed to another website, Network solutions. Alan
The roll pins in my case were tapered at each end and so positioned in the holes ok. I then just tapped them in. By their nature they compress into the hole and hold firm. Alan