Question to Tony K is -
Is a hole needed to be cut into the tank or is a sensor dropped into the
main tank through the outlet so that only a couple of wires come out?
Perhaps much to simple a set up to be possible?
JR (Bob) Gowing UK kit 327 in Oz
> For those using my pressure sensor chip set there is a new low cost
> prototyping board available for USD10 + p&p
>
> http://www.kiwacan.co.nz/products/kpic/kpic-2840p.shtml
>
> This board has a lot of the processor, timing and serial interface
> related circuit board already laid out which will result in an easier
> build of the pressure sensor. I have to build up another unit for myself
> for a domestic water tank and I'll be using this board to build up the
> circuit. Once I have done this I'll add some as built photos to the
> existing documentation which can still be found at
> www.kaon.co.nz/europa/fuelgaugev3.pdf
>
> Regards
>
> Tony
>
>
> --
>
>
|